Hazard Analysis Critical Control Point (HACCP) – Based
PURPOSE: To prevent foodborne illness by ensuring that all potentially hazardous foods are held under the proper temperature.
SCOPE: This procedure applies to foodservice employees who prepare and serve food.
KEYWORDS: Cross-Contamination, Temperatures, Holding, Hot Holding, Cold Holding, Storage
1. Train foodservice employees on using the procedures in this Standard Operating Procedure. Refer to the Using and Calibrating Thermometers Standard Operating Procedure.
2. Follow state or local health department requirements.
3. Minnesota Food Code:
• Hold hot foods at 140° F or above.
• Hold cold foods at 41° F or below.
4. Preheat steam tables and hot boxes.
1. Use a clean, sanitized, and calibrated probe thermometer to measure the temperature of the food.
2. Take temperatures of foods by inserting the thermometer near the surface of the products, at the thickest part, and at other various locations.
3. Take temperatures of holding units by placing a calibrated thermometer in the coolest part of a hot holding unit or warmest part of a cold holding unit.
4. For hot foods held for service:
• Verify that the air/water temperature of any unit is at 140° F or above before use.
• Reheat foods in accordance with Minnesota Food Code regulations. All reheated foods shall be reheated so that all parts of the food reach a temperature of at least 74° C (165° F) for 15 seconds.
• All hot potentially hazardous foods should be 140° F or above before placing the food out for display or service.
• Take the internal temperature of food before placing it on a steam table or in a hot holding unit and at least every two hours thereafter.
5. For cold foods held for service:
• Verify that the air/water temperature of any unit is at 41° F or below before use.
• Chill foods, if applicable, in accordance with the Cooling Potentially Hazardous Foods Standard Operating Procedure.
• All cold potentially hazardous foods should be 41° F or below before placing the food out for display or service.
• Take the internal temperature of the food before placing it onto any salad bar, display cooler, or cold serving line and at least every two hours thereafter.
6. For cold foods in storage:
• Take the internal temperature of the food before placing it into any walk-in cooler or reach-in cold holding unit.
• Chill food in accordance with the Cooling Potentially Hazardous Foods Standard Operating Procedure if the food is not 41° F or below.
• Verify that the air temperature of any cold holding unit is at 41° F or below before use and at least every four hours thereafter during all hours of operation.
1. Retrain any foodservice employee found not following the procedures in this Standard Operating Procedure.
2. For hot foods:
• Reheat the food to 165° F for 15 seconds if the temperature is found to be below 140° F and the last temperature measurement was 140° F or higher and taken within the last two hours. Repair or reset holding equipment before returning the food to the unit, if applicable.
• Discard the food if it cannot be determined how long the food temperature was below 140° F.
3. For cold foods:
• Rapidly chill the food using an appropriate cooling method if the temperature is found to be above 41° F and the last temperature measurement was 41° F or below and taken within the last two hours:
o Place food in shallow containers (no more than four inches deep) and uncovered on the top shelf in the back of the walk-in or reach-in cooler.
o Use a quick-chill unit like a blast chiller.
o Stir the food in a container placed in an ice water bath.
o Add ice as an ingredient.
o Separate food into smaller or thinner portions.
4. Repair or reset holding equipment before returning the food to the unit, if applicable.
5. Discard the food if it cannot be determined how long the food temperature was above 41° F.
VERIFICATION AND RECORD KEEPING:
Foodservice employees will record temperature of food items and document corrective actions taken on the Hot and Cold Holding Temperature Log. A designated foodservice employee will record air temperatures of coolers and cold holding units on the Refrigeration Logs. The foodservice manager will verify that foodservice employees have taken the required holding temperatures by visually monitoring foodservice employees during the shift and reviewing the temperature logs at the close of each day. The temperature logs are to be kept on file for a minimum of one year.
DATE IMPLEMENTED: BY:
DATE REVIEWED: BY:
DATE REVISED: BY: